Roller Bracket Assembly
Assembly and Assembly Drawing of parts previously modelled.
Part A Assembly
This problem comes from Boundy (Engineering Drawing textbook)The original detail drawings are in Inventor_Exercises.pdf (p46)
Assembled Roller components
General Plan
- Make an assembly of bushes pressed into the roller.
- Base is the first part of main assembly, add Brackets, Spindle.
- Insert the previous Roller Assembly as a sub-Assembly
- Finish off with bolts, grease nipple
- All parts are properly constrained (locked), but roller can rotate on spindle
- Base is the first (grounded) part.
Part B Assembly Drawing
Refer to Inventor Tutorial: AssembliesModifications
- Show a sectioned view of the assembly as shown below (i.e. the front view at bottom of page)